General Tech Help Good at troubleshooting? Have a non specific issue? Discuss general tech topics here.

Reving problem

Thread Tools
 
Search this Thread
 
  #1  
Old 07-26-2007 | 04:10 PM
Pooter83651's Avatar
Thread Starter
|
Junior Member
Joined: Jul 2007
Posts: 1
Default Reving problem

Hello everyone,
Any help you can give me would be great! 2004 Hyundai Elentra 5 speed39,000K
Ok, here is my porblem. When I start my car it rev's alot longer then it should then it will die down. Also, when I am driving it will do the same thing, but not every time. it also doesn't do it an any particular gear. But sinceI use the lowergears most often (city driving) thats when it seems to happen. Sometimes it will stop by itself, or sometimes I need to hit the gas a little for it to stop. its been happening for not quite a week now. I am taking it in for servace tomorrow7/27/07)and was wondering if its something that is going to cost me lots of $$$. Thanks to anyone that can help.
 
  #2  
Old 07-26-2007 | 08:49 PM
mechanic98's Avatar
Member
Joined: Jul 2007
Posts: 56
From:
Default RE: Reving problem

It could be a lot of things... it should be covered under warranty. Check to see if anything is making the Accellerator pedel stick... make sure it moves freely... also make sure that the Floor Mat is not up against it, causing it to get stuck... Just basic stuff that i've seen this type simptom before.
 
  #3  
Old 07-30-2007 | 11:11 PM
bob2007's Avatar
Junior Member
Joined: Jul 2007
Posts: 3
Default RE: Reving problem

possible throttle position sensor that went bad in my accent also
 
  #4  
Old 07-31-2007 | 07:06 AM
mechanic98's Avatar
Member
Joined: Jul 2007
Posts: 56
From:
Default RE: Reving problem

Any word yet, from the service visit?
 
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
anita72
Hyundai Santa Fe
0
03-14-2011 02:17 AM
VASLEJEAN
General Tech Help
7
05-24-2009 08:40 PM
joephish
Hyundai Sonata
3
11-18-2008 10:27 PM
blueboy_ju
Hyundai Coupe
1
01-28-2007 05:17 PM




All times are GMT -5. The time now is 03:23 AM.